Alamo 60C Operator's Manuel de l'opérateur télécharger pdf (Page 43)

ASSEMBLY

BH20 Series 04/13 Assembly Section 3-3

ASSEMBLY

SET UP INSTRUCTIONS - QUICK HITCH

1. With the mower sitting flat on the ground loosen the fasteners attaching the “A” frame struts to the frame

and rotate up into the vertical position.

2. Rotate the Pivot Arm toward the rear of the machine and remove the capscrews, bushings and locknuts.

3. Rotate the yoke straps over so the top hole align with the slotted hole in the “Pivot Arm.

4. Place a bushing in the slotted hole of the Pivot Arm and re-install capscrew and locknut. Place the remain-

ing bushing under the angled end of the Pivot Arm, align holes in yoke straps and bushing and re-install

remaining capscrew and locknut.

5. Tighten the fasteners enough to take out any slack but not so tight that the pivot arm can not move freely.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 137 138

Pas de commentaire

Alamo 60C Operator's Manuel de l'opérateur Page 43