Alamo 60C Operator's Manuel de l'opérateur télécharger pdf (Page 42)

ASSEMBLY

BH20 SeriesSeries 04/13 Assembly Section 3-2

ASSEMBLY

DEALER SETUP INSTRUCTIONS

Set up mower as received from factory with these instructions.

This BH20 Series is shipped partially assembled. Assembly will be easier if components are aligned and loosely

assembled before tightening hardware. Refer to bolt torque chart in Maintenance Section. All fasteners are

Grade 5 unless otherwise specified.

1. Position on hard level surface.

2. Apply light coat of oil to gearbox input shaft.

“A” FRAME ASSEMBLY

1. Swing “A” Frame up to the vertical position.

2. Remove front capscrew, bushing and locknut

from the yoke.

3. Swing the pivot arm on top of the “A” Frame up

and place the bushing from the yoke in the

slotted hole in the pivot arm. Raise the yoke up

to a point that the pivot arm slotted hole with

bushing align between the yoke and the

bushing is in line with the front holes of the

yoke. NOTE: The slant cut of the pivot arm

should be resting atop the second bushing of

the yoke.

4. Re-install the capscrew through the yoke,

bushing and pivot arm. Install the locknut but

not so tight that the pivot arm cannot flex

between the yoke.

HITCH PINS

During shipping the Hitch Pins may both be stored on one side of the lift brackets. Remove one of the hitch

pins and move to the opposite side hitch bracket. The following diagram shows proper hitch pin locations for

different hitch point set up.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 137 138

Pas de commentaire

Alamo 60C Operator's Manuel de l'opérateur Page 42